Be sure to observe the following instructions when separating rear stop lamp and turn signal lamp.
Related Contents:
2024.02 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download
HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download
Add a short pin connector for flasher cutting
• Prepare the short pin below which is available as a spare parts.
Part No. :82235-E0280
• Turn the starter switch to “LOCK” position, wait at least 10 minutes, and disconnect the negative terminal of battery before start work.
• The short pin connector connect to the connector which fixed to the protector.
• The turn stop dual output line of the BCM switches to the stop single output line of the BCM by connecting short pin connector to the connector. •••••
[NOTE]
• Make sure that the short pin connector is connected to the connector.
If the connector is not connected sufficiently, a circuit will return to the original condition.
[CAUTION]
The rear turn lamp connection will be cut out after this modifying, therefore, the following additional modifying is required.
More case for HINO please refer to:HINO Trouble Repair
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…