How to Install OEM STYLE DUAL HD DASH CAM on 2008+ Mercedes W204 C-Class

This instruction will show you guide on how to install OEM style dual HD dash cam on 2008+ Mercedes W204 C300.

More W204 repair cases, please refer to BENZ W204 PROJECT.

 

Procedures:

Use a trim tool to remove the stock trim covering the rain sensor

Slides the new cover with camera,and clipped right in. Remember remove the film on the camera.

Connect the power wire and rear camera connector and hide the wires up through upper frame.

Take both of the wires and sneak it along the edge all the way towards the back

Sitting in the back seat, one wire will go to the fuse box and other one will be routed along the top to plug the rear camera.

Mount rear camera in the center of the rear windshield, plug in the connector

Sneak power wire behind the seat here

Go to the back of the trunk, sneak power wire to the fuse box.

Attention: Disconnect the car’s battery before attempting to connect the dash cam wires to the fuse box.

The black wire is the ground wire, ground it to this bolt

The yellow wire requires a constant voltage, so we rigged up to the fuse #74 with the right side being the wire side and the left side is the hot side.

Same thing for the red in fuse #71, the right side is the wire side and left side is the hot side.

Now we can go and install the app.

Use a smart phone scan barcode on the instruction manual, then pair the device, follow the step-by-step instructions and set up the dash cam.

 

Here is cases about auto camera for further reference: REAR VIEW CAMERA TROUBLE.

 

Kevin

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

3 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

2 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

5 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago