Parking sensors could very well be one of the best comfort features to install by yourself if your vehicle does not have them.This instruction show you guide on how to install parking sensors for Volkswagen Beetle.More DIY cases for VW please refer to:VW Trouble Repair.
Preparations:
Parking Sensors
Tools
Procedurs:
Firstly,disassemble the car interior details for the installation of the control unit and wiring.
Then remove the taillights and the rear bumper
Route the wiring harness from the control unit to the rear bumpter and other components in the side
Don’t forget to install a buzzer that will give an audible warning when parking.
Now prepare the openings for parking sensor
Open the holes for the sensor with a cutting tool from the manufacturer
Once you have made openings for them,install the parking sensors with brackets in their marked default places.And then connect the cable harness
After then remount the rear bumper with the installed park sensors and insert back the rear lights
If you wish to do so,perform the same installation steps for the front bumper
Connect the wires to the control unit
Install the park control button
At the end you need coding for parking sensors for your Volkswagen,please refer to:How to Code Parking Sensor Function for Volksagen Beetle by OBDeleven
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…