Heavy Equipment Repair

How to Perform EOL Test for Deutz Tier4F Engine

Deutz engine  EOL test (end of line) is required to ensure the EAT functionality. Conditions for the start of the
EOL-test:


Engine coolant temperature > 70 °C
Exhaust gas temperature after DOC (before SCR if CSF System) < 300°C
DEF tank filled to minimum level (>15%)The stationary condition must be met.
After the requirement of the test it must be confirmed with the release button (HW / CAN) on the instrument side.

 

Related Contents:

2023 Deutz Serdia2010 v14.1.9.1 Diagnostic Software Free Download

Deutz Diagnostic Kit DECOM for Deutz Engine

 

Test Procedure:
• Testing of system components (sensors, actuators, wiring, ECU)
There must be no active faults of the EAT system present
• Leak check, visual inspection
In normal operation, a pressure of 9 bar in the pressure line is built up in the dosing.
In this case should be no leakage at the lines and their connections.

Functional verification
• During the EOL tests, the machine must be parked and it must be ensured that no additional functions can be activated to disrupt the process.
• During the regeneration the plausibility of the measured values of the individual sensors is checked.
• The temperature sensors before and after DOC are checked for the correct driving position (interchangeability).

Deutz Communicator
• The functionality of the SCR system is on the evaluation of the NOx conversion rate. The NOx values are compared before and after the SCR catalyst. When setting a difference between the values after the DEF dosing, the functionality is confirmed.
• The total EOL test is deemed passed when the temperature sensors before / after DOC are installed correctly, a NOx conversion rate reaches> 50% and no error is set during regeneration.

 

auto

Recent Posts

How to Remove Second Tank for CLAAS AXION 960-920 Tractor

This instruction show you guide on how to remove second tank for CLAAS AXION 960-920…

8 hours ago

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

3 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

5 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 week ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

2 weeks ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

3 weeks ago