Categories: Auto Key Program

How to Program Remote Fob for Ford/GM/Honda Manually

When you lose your key remote fob or make them disable, how to do? Find locksmiths to make one with key programmer, for it can work on Aftermarket & OEM Remote Key Fob’s; but today, I am willing to share with you key remote fob procedures on Ford, GM and Honda.

 

FORD key pads

Put in permanent factory code

Press the 1/2 button within 5 seconds to access to programming mode

Enter new code after 5 seconds, doors will lock, unlock to verify code, which erases previous codes remotes, and will also need to be programmed.

FORD key pads/remotes

Insert key, turn ignition off-to- on eight times in succession, ending with key in on position doors will lock, unlock to verify in programming mode

Press any button on new remote, doors will lock, unlock to verify

Do the previous step with the second remote, doors will lock unlock to verify.

Turn ignition switch off. Doors will again lock, unlock to verify. 

 

GM pass lock relearns

Ignition switch to “run” position, try to start and let key return to “run” position

Approx ten minutes security light will go off

Turn off key and wait 5 seconds

Repeat 2 more times for a total of 3 relearns.

Turn key off, then start it

HONDA sliding door re-homes

Clear the sliding door trouble codes by removing the # 13 (7.5) fuse from the passenger’s under-dash fuse box for 10 seconds.

Then put the fuse back in.

Turn off the main door switch; make sure that the ignition switch is off.

Manually open the sliding door and make sure it’s fully open.

Turn the ignition switch on, and then turn on the door switch.

Push and hold the CLOSE side of the dashboard door switch for that door until the door is fully closed.

Try the door operation with the dashboard door switch, the remote and the door handles.

According to the above key fob reprogramming procedures, it is not so difficult in it. Of course, you could also find experienced mechanics to serve you; or if you are professionals, you could search more advanced locksmith tools to serve your clients.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 week ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago