How to Register NATS Key for Nissan Almera N17 by Launch X431

After replace ECM for Nissan,you will get trouble code P1614,it require you to  register keys,so here car-auto-repair.com show you guide on how to register NATS key for Nissan N17 by Launch X431.More Launch X431 feedback,please refer to Launch X431 Feedback.

 

Preparations:

2021 LAUNCH X431 PRO3S

 

Procedures:

Connect Launch X431 device to Nissan Almera,then enter menu to select “Asian”–>”Nissan”–>”ALMERA”…”Health Report”

DTC P1614 show here:Chain of Immu-key

Back to menu to select “NATS”

Select “After replacing or installing operating”

Select “Replace BCM”

Here it show your password here:2324

Then click “OK” to continue

Input password “2324”,click OK

Insert ignition key into ignition key cylinder and turn ignition switch to the ON position

After then the system will proceed to initialization ECU automatically.

Click “OK” to continue

Follow the steps insert immo key security indicator blink 5 times

And repeat steps to register all keys

Once done all keys can start engine

auto

Recent Posts

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

2 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

5 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago

How to do Perform Cylinder Cut-off Test for Massey Ferguson Tractor

This instruction show you guide on how to use AGCO EDT diagnostic software to perform…

2 weeks ago