How to Remove Injector for Mitsubishi D04EG Diesel Engine

This instruction show you guide on how to remove injector for Mitsubishi D04EG diesel engine.

 

Related Contents:

Mitsubishi V.C.I Diagnostic Kit

Mitsubishi EngineScope Diagnostic Software

 

Procedures:

(1) Remove the harness.
(2) Fix the fuel inlet connector of injector with wrench,loosen the injection pipe nut and remove the injection pipe.


(3) Fully press the pin at the top injector and remove the leak-off hose.
(4) Remove the connector of main harness and the injector connector.


(5) Loosen the nozzle gland bolt, and remove the injector together with the nozzle gland using the injector puller.
(6) Remove the gasket at injector inserting port in cylinder head.


(7) Install the protection cap to the injector immediately after the removal to avoid dust entering.
Note: Wait 30 seconds or more after the engine stop to start the injector removal job.

auto

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

2 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

5 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

3 weeks ago