Heavy Equipment Repair

How to Remove Main Fuel Tank for CLAAS AXION 950 Tractor?

Here is the instruction show you guide on how to remove main fuel tank for CLAAS AXION 950 tractor.

 

Related Contents:

CLAAS CDS 7.5 Diagnostic Software 2021 2020 Free Download

CLAAS 4x CAN Diagnostic Interface

Claas WebTIC Offline Repair & Service 2024 2015 Free Download

 

 

Procedures:

Removal

► Remove the rear left-hand wheel.

► Drain the tank

► Set the battery master switch to the off position.

► Remove the cables (1).

► Remove the battery.

► Remove the mounting nuts (1).

► Remove the protection panel between the two tanks (2).

► Close the isolation valves (1).

Note: If there is still fuel in the tank, the handle can be removed to prevent the valve from opening when a tank is being transported:

► Remove the collars (2).

► Disconnect the “E132” work light.

► Remove the mounting bolts (1).

► Remove the grille (2).

► Remove the mounting bolts (3).

► Remove the panel (4).

► Remove the cover (1).

► Mark and remove the harnesses.

► Leave the harnesses (1) on the plate.

► Remove the bolts (1).

► Remove the tank flap.

► Remove the bolts (1).

► Remove the panel (2).

► Remove the bolts (3) to tilt the last step.

► Support the tank using a lifting table.

► Remove the bolts (4).

► Tilt and lock the step to access the harnesses.

► Cut the collars (5).

► Fit all the harnesses (5) on the gearbox.

► Disconnect the connections (1).

► Disconnect the connections (1) and (2).

► Remove the cover of the gauge (1).

► Remove the pipes (1).

► Disconnect the gauge plug (2).

► Fit the special tools on the coolant hoses (3).

► Remove the coolant hoses (3).

► Remove the overfill tube (4).

► Disconnect the connector (5).

► Move the harnesses corresponding to the front part on the engine.

► Disconnect the connector (1).

► Remove the pipes (2).

► Place the harness (1) and the pipes (2) on the tank.

► Remove the mounting bolts (1).

► Remove the tank.

More repair case for CLAAS,please refer to CLAAS Trouble Repair

auto

Recent Posts

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 day ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

4 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago

How to do Perform Cylinder Cut-off Test for Massey Ferguson Tractor

This instruction show you guide on how to use AGCO EDT diagnostic software to perform…

2 weeks ago