Here is the instruction on how to remove MTU ECU4 12-16v 4000 engine.
1 Governor, ECU 4
2 Engine wiring connections
Related Contents:
2022 MTU DiaSys 2.74 2.72 Engine Diagnostic Software Free Download
MTU Engine Diagnostic USB-to-CAN Adapter with Cables
Removal
The arrangement and position of the ECU 4 is shown
Release all union nuts (1) of bayonet connector and
remove all connectors (2) from the ECU 4 (3).
Note: The union nuts can be easily released with connector pliers (7).
Seal all open connecting sockets of the ECU 4 and all engine wiring connectors with dust caps.
Unscrew ground lead (5) from the ECU 4.
Release the four securing screws (M6 x 60) (4) for the ECU 4 and remove the ECU 4.
Note: The ECU 4 weighs approx. 7 kg.
Inside the ECU 4 there are two data modules (MEM) on which engine- and plant-specific software is stored.
When changing ECU 4, these data modules must be taken over into the new ECU 4.
The procedure is described in the Electronics Documentation.
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…
This instruction show you guide on how to use AGCO EDT diagnostic software to perform…
This instruction show you guide on how to remove folding stairway and surrounding part for…