This instruction show you guide on how to repair JCB equipment K0124 boot pressure high trouble.The measured boost pressure rises above the maximum limit during operation.More repair case for JCB,please refer to:JCB Trouble Repair
Related Content:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2024 JCB ServiceMaster 4 v24.3.1 Free Download for Win 10 Win11
Possible causes are:
Too high fuel injection quantity (mg/str) for the engine type (tuning chip).
Incorrect nozzles for the engine type.
An incorrect turbo charger for the engine type.
The turbo waste gate is stuck to close.
Reaction in EEM
The FC is stored and the warning lamp is activated. Engine power will be reduced (Degradation Level 2). The CAN message indicates active fault. No recovery before system reset.
Solution
Find the cause for the high boost pressure indication:
Check that the control system is configured according to the original specification, and that no additional devices have been attached.
Check that the nozzles and the turbocharger meet the original specifications.
Check that the turbo waste gate can be moved by hand when the waste gate actuator has no power.
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…
Here is the instruction show you guide on how to solve Caterpillar C9 fault code 64-2…
This instruction show you guide on how to bleed air from the fuel system for…
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…