Categories: Do It Youself

How to Replace Cabin Air Filter for Benz W204

Every 10,000 miles or so, you should change the cabin air filters in your Mercedes-Benz. You should change it sooner if you live in a dusty climate or do a lot of driving on non-paved roads. The cabin air filters helps protect the air that you breathe inside the car. Replacement is a snap and should take less than an hour.Here is a easy step-by-step guide on how to replace cabin air filter for Benz W204.

 

Applies to:C350 (2007-14), C180 (2007-14), C200 (2007-14), C230 (2007-14), C250 (2007-14), C280 (2007-14), C300 (2007-14), C320 (2007-14)

 

Time: 30-60 minutes

Tab: $23 to $50

Talent: 1

Tools: T20 Torx driver, rag

Parts Required: New air filter

Hot Tip: Place a cloth under the filter when removing

Performance Gain: Breathing cleaner air

Complementary Modification: Change engine air filter

 

Mercedes Benz W204 Cabin Air Filter Replacement:

The cabin air filter is located in the passenger side footwell.To access it you must first remove teh kick panel or protective piece that is up under the dash.Use a T20 Torx and remove the three screws holding it in place (red arrows) and pivot it down at the front.

Disconnect the electrical connection for the footwell light (red arrow).

Pull out the connection for the footwell temperature sensor (red arrow)

You can now slide the piece all the way down and then pull it out.

With the panel removed locate the air filter housing up by the center tunnel.Slide the plastic clip towards the rear of the vehicle (red arrow)

With the clip forward you can simply pull the air filter down and out from the housing (red arrow)

If you suspect the filter to be really dirty you can lay a rag down on the carpet to keep the dirt and debris from causing a mess.Installation is the reverse of removal.

auto

Recent Posts

Doosan Bobcat Machine Electric Fault Troubleshooting Guide Tip

This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…

15 hours ago

How to Download and Install JCB DLA 2.0 Driver?

It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…

7 days ago

How to Solve Deutz EMR3 Engine 94 /523239/FrmMngDecV1?

Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…

1 week ago

How to Solve AGCO Machine Trouble Urea pressure too high?

This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…

2 weeks ago

How to Install Left-hand Drum Bearing Assembly for CLAAS LEXION 480

Here is the instruction show you guide on how to install the left-hand drum bearing…

3 weeks ago

How to Remove and Replace Loader Lift Ram for JCB 3CX 4CX Machine

This instruction show you guide on how to remove and replace loader lift ram for…

4 weeks ago