Here is a service repair instruction on how to replace exhaust pipe flexible tube for Volvo EC480 excavator.More about Volvo heavy duty equipment service manual,please recommend you install Volvo PROSIS Parts+Service repair manual
Procedures:
NOTE!
If the flexible tube is to be reused, mark the tube by drawing a line between the clamps.
1.Park the machine in service position B
2.Open the engine hood.
3.Remove the foot step.
4.Remove the clamps.
5.Remove the flexible tube.
6.Install the new gaskets on the flanges.
7.Install a new flexible tube.
8.Install the upper end of the flexible tube.
9.Install and tighten the new upper clamps.
Tightening torque
NOTE!
Make sure there are no tensions on the flexible tube.
Make sure the clamps are placed right in the flange coupling.
10.Control from two directions that the flexible tube is straight and not bent.
11.If the tube is bent, loosen the clamps to the DPF and adjust the DPF until the tube is straight.
12.Make sure that the markings on the flexible tube is lined and the flow direction is as marked arrow on the label.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…