Categories: Do It Youself

How to replace spark plug correctly by yourself (video)

Spark plug is an essential part of any working combustion engine and all modern cars. Like anything, they wear out after long time using. And they are a relatively easy-to-fix issue on your car. If you hire someone to replace it, it will cost a lot and so not profitable. Because is so easy to do it, so i share this guide on how to replace spark plug correctly by yourself.

 

Tools you need:

1.Ratchet wrench

2.Extension bar

3.Spark plug socket

4.Gap gauge

Step 1: According to your user manual, locate where the spark plugs are. Usually, open the hood or bonnet of your car, you will see a bundle of 4-8 wires leading to different points on the engine compartment. The spark plugs are located at the engine end of these wires, under the plug covers that attach them.

Step 2: Pull the wire plug from the engine by gripping it as closely to the bottom as possible and working it gently and carefully off to reveal the spark plug.

Step 3: Get stander number of spark plug gap and use gap gauge to set the number to new spark plug. The gapping number guide is on the hood or bonnet, you need to find it and use gap gauge to set number to new spark. My car is 1.1.

Step 4: Use spark-plug socket and extension bar to install new spark plug.

At the end of article, more detail information about replacement of spark plug at below video guide.

auto

Recent Posts

QSK60 CM2358 Engine Camshaft Speed/Position Sensor Data Erratic Incorrect

This illustration show you guide on how to repair Cummings QSK60 CM2358 engine camshaft speed/position…

4 days ago

Fendt MT800E Tractor DEF Tank Temperature Does Not Change Solution

Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…

6 days ago

HITACHI Construction 4JJ1 P0092 Fuel Pressure Regulator Control Circuit High

Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…

1 week ago

How to Solve Perkins 1106D EPG Engine E398 Low Fuel Rail Pressure Error

Here is the illustration show you guide on how to solve Perkins 1106D electric power…

1 week ago

Deutz EMR3 Aassembly Inspection and Initialisation Test Guide

Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…

1 week ago

HITACHI ZX-5 Excavator No Load Max Differential Pressure Measurement Guide

This instruction show you guide on how to perform No load max differential pressure measurement…

1 week ago