This instruction show you guide on how to reset application controller 1100 for John Deere 9620R 4WD tractor.
Related Contents:
John Deere Service Advisor 5.3.235 AG+CF 2024 2020 2018 Free Download
2024 John Deere Parts ADVISOR AG + CF + CCE Free Download
John Deere Service Advisor EDL2
IMPORTANT:
Do not connect the Application Controller 1100 while machine is powered ON. Connecting while powered can create CAN bus communication errors and generate hydraulic control unit faults.
1.Turn OFF the machine
2.Disconnect the constant power connector (A) and the option connector (B).
PC22232-UN: Constant Power Connector
A – Constant Power Connector
B – Option Connector
PC22233-UN: Option Connector
A – Constant Power Connector
B – Option Connector
3.Disconnect the CAN bus T-connectors (C) and connect the 4-pin CAN bus connector (D) directly to the ISO implement connector (E).
PC22234-UN: CAN Bus Connectors
C – CAN Bus T-Connectors
D – 4-Pin CAN Bus Connector
E – ISO Implement Connector
4.Start the machine. Once all systems start up, turn OFF the machine.
5.Reconnect the constant power harness and option connector.
6.Reconnect the CAN bus T-connectors between the 4-pin connector and the ISO implement connector.
More repair case for John Deere,please refer to:John Deere Trouble Repair
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…
This instruction show you guide on how to use AGCO EDT diagnostic software to perform…