How to Reset Service Interval for Land Rover L359 by JLR SDD

This post focus on how to use JLR SDD to reset service interval for Land Rover L359 2010 by JLR SDD.

 

Preparations:

How to Install JLR SDD Diagnostic Software

Newest JLR SDD V154 Software Free Download

 

Procedures:

Connect the JLR SDD hardware device to vehicle,and run the JLR SDD on your laptop.

Click SDD

Click[Auto VIN Read]

 

Reading VIN…

 

Click [Diagnosis]

Symptom Selection and click [Continue]

Click [Recommendations]

Click [Run] Special applications: Service interval reset

Click [Agree]

Set the ignition switch to on. Press tick to continue

 

Press tick to continue

Ensure an approved battery charger is connected.

Set the ignition switch to off. Press tick to continue

Processing car configuration file data is completed.

Make sure the ignition is switched on. Press tick to continue

Service interval:Read the vehicles time and distance related is completed

Global real time:Read the vehicles time and distance related is completed

Set the ignition switch to off. Press tick to continue

Make sure the ignition is switched on. Press tick to continue

Resetting the service interval is completed

Set the ignition to off. Press tick to continue

Set the ignition to on. Press tick to continue

Clear the fault codes? Press tick to continue

Clearing the fault codes.

Clear the fault codes is completed. Press tick to continue

Set the ignition switch to off. Press tick to continue

Initialising… Press tick to continue

Set the ignition switch to on. Press tick to continue

Control module procedure completed successfully. Press tick to continue

Set the ignition switch to off. Press tick to complete

 

auto

Recent Posts

JCB JS140/205/215 Excavator C1022-13 Coolant Temperature Sensor Open Circuit

This instruction show you guide on how to solve JCB JS140/205/215 excavator C1022-13 trouble code coolant…

2 days ago

How to Diagnostic and Repair PCC1302 PowerCommand Code 2972 – Field Overload

If the time that the Field AVR Duty Cycle is operating at maximum output is…

3 days ago

Caterpillar C9 Engine 15 164-3 Injection Actuation Pressure Voltage High

The Engine Control Module(ECM) detects the following conditions: The voltage for the injection actuation pressure…

4 days ago

Volvo and Mack EPA 10 Engine Hydrocarbon Dosing Control Valve Test by JPRO

This instruction show you guide on how to perform hydrocarbon dosing control valve test for…

1 week ago

Fendt Tractor SPN 100 FMI 31 Oil Pressure Sensor Defect Solution

This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…

1 week ago

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure   Related Contents: 2024.06 Detroit Diesel…

2 weeks ago