This short post will show you guide on how to use Delphi DS150 2017 Rev. to scan ISS(Intelligent System Scan) on 2008 Ford Focus.If you are interested in Delphi DS150, please click here: Delphi Ds150.
Steps:
Connect Delphi Ds150 to vehicle, open software. Select vehicle model.
Select vehicle and type of system, click “ISS” on the right side down
Click “Petrol”
Turn ignition on, then click “OK”
System search in progress
Green means system search finished, no error codes found
Red means system search finished, error codes found
Orange means system finished, conflict in the choice of vehicle, manual choice required
System search complete, click “OK”
More cases about Ford focus, please refer to FORD FOCUS.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…