If you are a Nexiq USB Link2 users,you know that it can work with many diagnostic software,like CAT ET,Volvo PTT,ISUZU G-IDSS….But you need set correct adapter driver on related software.Here in this instruction car-auto-repair.com show you guide on how to set CAT ET diagnostic software work with Nexiq USB Link 2 adapter.
Related Contents:
CAT Adapter 3 ET4 478-0235 High Quality Diagnostic Adapter
Caterpillar SIS 2021 2019 2018 Full EPC+Service Manual Free Download
Caterpillar Factory 18 Digits Password Service
Preparations:
Caterpillar ET 2024A 2023C 2019C 2018A Electronic Technician Software Free Download
Procedures:
Run Caterpillar ET diagnostic software,then click “Stop Connect”
Select “Utilities”à”Preferences”à”Modify”
Select “Communications”à”RP1210 Compliant Device”
Click “Advanced” button
Now here select “USB-Link (1)-NEXIQ Technologies USB-Link 2”
Then click “OK”
Notice:if your connection by WIFI or Bluetooth,please select which you need.
Now it show current RP1210 device is “USB-Link (1)-NEXIQ Technologies USB-Link 2”
Click “OK” to finish setup
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…
This instruction show you guide on how to use AGCO EDT diagnostic software to perform…