How to Solve CNH DPA5 Incompatible with EST Software

If the DPA 5 firmware has been updated from the internet, it will have been flashed with firmware that is incompatible with the EST software, and will not communicate.So here,car-auto-repair.com show you how to recovery CNH DPA5 firmware after internet updating.

Related Contents:

2023 CNH EST 9.8 9.2New Holland Diagnostic Software Free Download

CNH DPA5 Diagnostic Kit

CNH eTimGo Offline

 

Notice:

DO NOT download any DPA5 firmware or utility from the internet.
DO NOT permit a third-party program to download DPA5 firmware.
DO NOT allow any technical support person with remote control of the computer to download a DPA5 utility.
Only a technical support person from CNH Industrial should advise on the EST software and DPA5
application

 

Firmware update tool download here

 

Only Firmware updates initiated by the CNH EST software must be installed on the DPA5.
If the DPA5 has been updated from the internet with non-compatible firmware (65.201) the following scenario will be seen:-
The firmware update prompt appears again with the message……..

the firmware has not been updated……..

The user then initiates the update, and the message then appears…………

the firmware in the DPA5 is newer than the firmware being reflashed……………..

The update then cancels.
When the user closes this message the EST once again prompts the user to reflash the DPA5. If the user closes the message, the EST closes. There is no way to bypass this firmware update, so there is no way to use the EST.

To recover this situation:
If any dealer has incorrectly installed 65.201, there is a utility that allows the EST to restore the DPA5 firmware to version 65.200.04. After running the utility, the EST will correctly program firmware version 65.200.04 to the DPA5 the next time the EST is run. This utility also configures the DG Tech download utility to stop prompting for updates. Find this utility in the EST Update Tool, My Other Updates tab. It is also in the ASIST EST Support page.

auto

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

5 hours ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

3 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

6 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago