Heavy Equipment Repair

How to Solve Fendt MT1149 Tractor DEF Tank Level Sensor Voltage Error

Here is an illustration show you guide on how to solve Fendt MT1149 tractor DEF tank level sensor voltage is above and below normal operating range.

 

 

Preparations:

AGCO EDT 2024

AGCO 2×4 CANUSB

 

 

Measured DEF tank level sensor voltage is above normal operating range

Diagnosis and solution

Clear the error log.

Restart the engine module.

If the fault code occurs again during the next driving cycle, check the following.

Make sure the DEF tank is full.

Check the DEF tank level sensor harness. Make sure the connections are good and the contacts are clean.

Replace the DEF tank level sensor. If the system is correct and the fault code is not active, the original sensor is bad.

Measured DEF tank level sensor voltage is below normal operating range

Diagnosis and solution

Clear the error log.

Restart the engine module.

If the fault code shows again during the next driving cycle, check the following.

Check the DEF tank level sensor harness. Make sure the connections are good and the contacts are clean.

Replace the DEF tank level sensor. If the system is correct and the fault code is not active, the original sensor is bad.

 

If you want more repair cases for Fendt tractor,please refer to Fendt Tractor Trouble Repair

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

21 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago