Here car-auto-repair.com show you guide on how to repair Scania truck ALM alarm system ALM 313 320 trouble code error.
Related Contents:
2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2024 2018 Scania Multi EPC Parts Catalogue Free Download
Motion and inclination detector, short circuit
Error identification
Motion and inclination detector T78 is short-circuited to ground/the voltage supply..
Cause
Fault in harness-to-component connectors or cable harness for motion and inclination detector T78.
Fault in motion and inclination detector T78.
Faulty ALM control unit E7.
Notes
–
Symptom
The motion and inclination detector does not work correctly.
Action
Check motion and inclination detector T78 and its connection.
Disconnect the motion and inclination detector.
Measure the pins in the nearest harness-to-component connector going to control unit pin A14.
Disconnect the harness-to-component connector on the control unit.
Measure for short circuits throughout the cable harness.
If there are a number of harness-to-component connectors between the motion and inclination detector and the control unit, also measure these in order to isolate the fault.
If the fault is not in the cable harness or motion and inclination detector, it is probably an internal fault in the control unit.
For more information about Scania truck,please refer to:Scania Trouble Repair.
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…
This instruction show you guide on how to use AGCO EDT diagnostic software to perform…