Categories: Auto Repair

How to Synchronize Dash to ECU for Ford Focus after ECU Replacement

In this instruction car-auto-repair.com show you guide on how to use Ford All in One software to synchronize dashboard to ECU after new ECU replacement.

 

Procedures:

Step 1:Read out dashboard EEPROM file from dashboard

Connect Orange 5 programmer(or other programmer supported) to dashboard

Run Orange 5 software

Click “Type”–>”MC68HC12”–>”04-MTRK”–>”MC9S12H256”

Then read ID and read EEPROM to save the file on your PC

Here save it as name “eprom dash focus”

 

Step 2:Read out ECU file

Here you need use programmer to read out ECU file before perform synchronizing

 

Step 3:Synchronize to ECU

Run Ford All in One software

Open ECU eeprom file and dash eeprom file you read before

Click “Synchro to ecu” and save it on your PC

 

After then you can use Fairdell HexCmp2 software to compare new ECU eeprom file with original one.

And then check it work,use programmer to write the new ECU eeprom file back to ECU.

auto

Recent Posts

Volvo and Mack EPA 10 Engine Hydrocarbon Dosing Control Valve Test by JPRO

This instruction show you guide on how to perform hydrocarbon dosing control valve test for…

2 days ago

Fendt Tractor SPN 100 FMI 31 Oil Pressure Sensor Defect Solution

This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…

4 days ago

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure   Related Contents: 2024.06 Detroit Diesel…

6 days ago

Perkins 800 Series Engine Water Temperature Regulator Housing Remove and Install

This instruction show you guide on how to remove and install water temperature regulator housing.…

1 week ago

Monza, Kadett and Ipanema Multec 700 GM ECU Components Pinout

Monza, Kadett and Ipanema Multec 700 GM ECU Components Pinout   Vehicles: Monza, Kadett and…

1 week ago

How to Remove Oil Pressure Regulation Valve for CLAAS AXION 950

This illustration show you guide on how to remove oil pressure regulation valve for CLAAS…

1 week ago