Categories: Do It Youself

How to Update BMW CIC Hard Disk Drive Music Track Database

The following procedure describes how to update the music track database on the hard disk drive of the CIC, using the Gracenote® database Update CD.

 

Note: The update procedure should only be performed with the ignition on (connect the battery

charger if necessary), and do not drive the vehicle or turn off the ignition while the update is in

progress. The update takes less than 10 minutes.

 

Procedures of BMW CIC Music Track Database Update:

 

1. Insert the Gracenote® database Update CD into the CIC drive.

2.Deactivate the“Split screen”feature if it is active.

3.Enter the Service Menu of the CIC as follows:

  • Call up the Start Menu
  • Push the controller in the up direction and hold for at least 10 seconds
  • Turn the controller 3 notches to the right
  • Turn the controller 3 notches to the left
  • Turn the controller 1 notch to the right
  • Turn the controller 1 notch to the left
  • Turn the controller 1 notch to the right
  • Press the controller down and release
  • The Service menu is now added as the last submenu to the menu Settings.

4.Once the Gracenote® database Update CD has been loaded, compare both database versions.

Hard Disk Drive (HDD) to Update CD

5.Start the installation of the Gracenote® databaseupdate only if the GNDB HDD version is not up-to-date.

6.The Gracenote® database update progress is shown in percentages.

7.After the Gracenote® database update is completed:

Remove the Gracenote® database Update CD from the drive.

auto

Recent Posts

MANITOU MT6034 Telehandlers PWP System Deactivation Tests

This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…

3 days ago

How to Solve Liebherr Machine ECU2 P1119 SCR System Plausibility Error

This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…

5 days ago

Bobcat Machine P18A5 Suction Line Heater Open Error Solution

This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…

1 week ago

AGCO Machine SPN 102 – FMI 31 Intake Manifold Pressure Drop Too High at Cranking

The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…

2 weeks ago

JCB 3CX 4CX Backhoe Loader Engine Throttle Cable Removal and Replacement

JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…

2 weeks ago

How to Replace Fuel Tank Breather Filter Element for Liebherr R9600 Excavator

Here is the instruction show you guide on how to replace fuel tank breather filter…

1 month ago