This post guide on how to update original VOCOM II 88894000 software and firmware.
Before update operations,you need to download the Vocom II driver.
Locate the saved file and extract the file contents.
If prompted for a password,please contact the IT Support desk1(877)978.6586 for information
Open the folder and install the file.
Open your PC,go to StartàAll Programs.Click on VOCOM II folder and then click to launch the VOCOM II Configuration Application.
Plug the VOCOM II into the PC USB port.The VOOM2 will display under “All device”
Note:Serial Number(SN) differs.Do not connect to the vehicle at this time.
When you receive the “Please update device firmware” pop up message.Click the “tick” to continue.Otherwise,click on the “Device software”tab.
Click “Update device”
The software will begin to update.
Note:Updating device can take a few minutes.
When the Update is complete.The VOCOM Configurator will refresh the settings.
Open Tech Tool and go to “Setting” to configure the adapter settings.
Here you can select the VOCOM II and the “Active” to enable.Next,click OK to close window.
Note:VOCOM I and VOCOM II use different drivers and must be active separately.
This instruction show you guide on how to solve Caterpillar C9 engine injection actuation pressure…
Here is the instruction show you guide on how to remove HV battery cooling fan…
Here is the instruction show you guide on how to solve Scania truck alarm system…
This instruction show you guide on how to repair Doosan stage V engine U02A2 timeout…
Here is the instruction show you guide on how to repair Doosan stage v egnine…
This instruction show you guide on how to use JPRO Diagnostic software to performance check…