Categories: Auto Coding

How To Use BMW E-sys Coding Software

Here comes the gudie on How to use BMW E-sys coding software.After you reading this article,hope you can use E-sys coding software to coding for you BMW.

 

What Tool you need for starting E-sys coding?

1. BMW E-sys Coding Software (BMW E-sys Coding Software Free Download)

2. BMW ENET Cable

3. Laptop which E-sys installed on.

BMW Coding/Flashing/Progrmming PDF+Video Guide

 

How To Use BMW E-sys Coding Software

 

Step 1: Install BMW E-sys Coding Software on you laptop.

Step 2: Connect cable to computer then to car.

Step 3: Open the E-sys software,and click the connect button.

Step 4: Select F series you are working on, my case F10 and select Connection via VIN and click “Connect”

Step 5: Click “OK”

Step 6: Click “Read”

Note:Option to save or not to save.

Step 7: Click “Read (VCM)”(Read SVT in newer E-Sys versions)

 

Step 8: Select CADF (only one with a green Check mark) file under the module you want to read

and select “Read Coding Data”

 

Step 9:Error Report, Click “Close” (or save if necessary)

Step 10:New option under CADF, a folder. Expand the folder by clicking + and right click that file, Select “EDIT FDL”

Step 11: Browse the folders till you find your option, I want option KOMFORTSCHLIESSUNG_FB

Step 12: Factory option set to nicht_active. Right click, select “Edit”

Step 13:Select option desired, in this case, select “aktiv”

Step 14: Once all changes have been made, Click the “Save” icon

Step 15: Once saved, click the green back arrow

Step 16: Right click FA, select “Activate FA”

Activating FA, just wait till it finishes. Once finished, FA should show (active) in green. If not, try again.

Note: If you do not activate FA as described in Step 19, you will receive this message

Step 17: Select the CAFD file that you just edited and then click “CODE FDL”

Step 18 :Coding FDL (progress)

Step 19:After it completes, Click “Close”

Step 20: Error report will open, view and click “Close” (or save if necessary)

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 week ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago