This instruction show you the test report on Ford IDS with FVDI J2534 diagnose Ford Focus 1.6L DURATCE VCT DPS6.And some my blog use also recommend to use Ford F-COM,for this tool test report,check here:Ford F-COM Test Reports,
Preparations:
How to Install Ford IDS Software
Procedures:
Connect FVDI J2534 interface to Ford Focus OBD port
Run FVDI Ford IDS software,then select “Start New Session”–>”All other”
Wait for communication establishing to PCM
After vehicle specification,it will show the vehicle information as below,select “Yes” to continue
Read and Clear DTCs:
Select “Self Test”–>”All CMDTCs”
Set the ignition switch to ON,then click “OK” button
Wait for Reading Continuous DTCs
After then,you will see the diagnostic trouble codes show as below,you can select to read the item for more information.
DataLogger (Live Data)
Back to menu to select “DataLogger”
Modules–>PCM
Now it show as below screen
Select “VREF”,and click “OK” button
Now it show the data as graphic
And you can press the accelerator pedal or other to test the live data
This instruction show you guide on how to perform hydrocarbon dosing control valve test for…
This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…
Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure Related Contents: 2024.06 Detroit Diesel…
This instruction show you guide on how to remove and install water temperature regulator housing.…
Monza, Kadett and Ipanema Multec 700 GM ECU Components Pinout Vehicles: Monza, Kadett and…
This illustration show you guide on how to remove oil pressure regulation valve for CLAAS…