This mini post show the test report from G-Scan2 engineer Scott,it show the guide on how to use G-scan to learn valvetronic limit positions for BMW 320I 2011.And for more G-scan2 diagnostic tool test report,check here:G-scan2 test report
Procedures:
Connect G-Scan2 to the BMW 320I,and the select “Diagnosis” menu and then select BMW 320I 2011 model.
After then select “DME(Digital Engine Electronic)”,click “OK” to continue
Select “Special Function”
Select “Learn Valvetronic limit positions”
Each time after repair work has been carried out on the Valvetronics system,the limit positions on the adjusting mechanism must be relearnt for minimum and maximum lift.
During the teaching process,the eccentric shaft is turned slowly in the direction of minimum lift until a point of mechanical resistance is reached.
This position at the mechanical resistance is reached.
This position at the mechanical limit position is stored
The same procedure applies to the maximum lift limit position.
Press “OK” to continue
Switch off terminal 15 and terminal R
Wait until Digital Motor Electronics main relay has deactivated.
Switch on terminal 15
Press “OK” to continue
The limit positions are taught in the next test step
Press “OK” to continue
In progress
Stop currently being learnt
Duration:max.20 seconds
Limit positions successfully learnt.
Done!