Categories: Auto Repair

How to Use G-scan 2 Reset VANOS Adaptation Values for BMW 320I 2011

This article show the test report of G-Scan2 perform resetting VANOS adaptation values for BMW 320I 2011.And for more G-scan2 diagnostic tool test report,check here:G-scan2 test report

 

Procedures:

Connect G-Scan2 to the BMW 320I,and the select “Diagnosis” menu and then select BMW 320I 2011 model.

After then select “DME(Digital Engine Electronic)”,click “OK” to continue

Select “Special Function”

Select “Reset VANOS adaptation values”

The adaptation values can be reset in the next test step.

Press “F1” to reset VANOS adaptation values

Adaptation values were reset,then press “OK” to continue

Switch off terminal 15 and terminal R

Wait 15 seconds until the reset adaptation values and variants are stored in the DME.

Then press”OK” to continue

Switch on terminal 15

Leave ignition switched on for at least 10 seconds,then press “OK” to continue

Service function finished.

Done!

auto

Recent Posts

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

3 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

6 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago

How to do Perform Cylinder Cut-off Test for Massey Ferguson Tractor

This instruction show you guide on how to use AGCO EDT diagnostic software to perform…

3 weeks ago