Categories: Auto Repair

How to Use G-Scan 2 to Reset Adaptation Values for BMW X3 2015

This article show the procedures on how to use G-scan 2 diagnostic tool to reset adaptation values for BMW X3 F25 2015.And for more G-Scan 2 test report,please check here:G-Scan 2 Test Projects.

 

Procedures:

Enter [DIAGNOSIS] menu to select vehicle model

BMW–>X Series–>X3(F25)(2010-present)

Then select [EGS(Electronic transmission management)],then select [OK] to continue

Select [Special Function]

Select [Display and reset adaptation values]

Here show the function as below:

F1:Display adaptation values

F2:Display adaptation counter

F3:Reset adaptation values

F4:End service function

Select [F1] to view the adaptation values

Press [Cancel] to back,then select [F3] to reset adaptation values

Then it will show you with the massage:

Resetting the transmission adaptation values helps to restore the delivery status of the transmission in response to the problem being reported.

Select [OK] to reset adaptation values

Done!

auto

Recent Posts

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 day ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

4 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago

How to do Perform Cylinder Cut-off Test for Massey Ferguson Tractor

This instruction show you guide on how to use AGCO EDT diagnostic software to perform…

2 weeks ago