Here is a short demonstration of SAS calibration on 2019 Kia Soul.If you want to know more about G-Scan function, please refer to G-Scan test cases.
Steps:
Connect G-Scan3 to Kia Soul obd port, then enter menu to select “Diagnosis”
Select “KIA”
Select “S/W Management
Scroll down and search for “EPS Module” then hit it, clilck “OK”
When you replace EPS ECU or perform EPS related work, you need to calibrate steering Angle Sensor. You need to perform this function with IG ON and ENGINE OFF
Turn the steering wheel to center position.
Then hit “OK” to exit.
SAS Calibration is completed. Turn IG OFF for 10 seconds and ON again.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…