Categories: How To

How to Use JPRO Diagnostic Software Vehicle Data Points Function

When a vehicle is selected in the vehicle readiness window, the following are the displayed data points: Cruise set speed limit, road speed limit, idle shutdown time, battery voltage, total average fuel economy, total engine run time, odometer, engine speed, DPF lamp, EHST (exhaust system high temperature) lamp, trailer and tractor ABS lamps, DPF soot level, DPF derate, total idle hours, total idle fuel used, and consumable fluid status.

 

Related Contents:

2024 JPRO Noregon Commercial Fleet Diagnostics Free Download

Noregon JPRO DLA+ 2.0 Adapter

 

Click on the Consumable Fluids status image to view fluid level details.

Clicking the Idle Shutdown gauge when Click to Change is displayed will launch the Idle Shutdown test.

Clicking either the Cruise Speed Limit or Road Speed Limit gauge when Click to Change is displayed will launch the appropriate Road & Cruise Speed Limits test.

Clicking the PTO Status gauge when Click to Change is displayed will launch the PTO Parameters test.

 

Engine Data Points

Air inlet pressure, exhaust pressure, fuel pressure, boost pressure, oil pressure, oil temperature, coolant temperature, fuel temperature, exhaust temperature, air inlet temperature, and battery voltage.

 

Transmission Data Points

Transmission input speed, transmission output speed, transmission fluid temperature, gear selected, gear obtained,and battery voltage.

 

Brake Data Points

Road speed, tractor ABS lamp, trailer ABS lamp, wheel speeds (J1708 only), and relative wheel speeds (J1939 only).

Bendix Intellipark switches are displayed for the components detected on the vehicle. The Bendix Intellipark lights will match those displayed by the ECU.

MultiValve: Displays reported switch positions for the red trailer or yellow tractor Intellipark switches.

Push/Pull Switch: Displays reported switch position in either the left or right position, which should match the position of the physical switch in the cab.

 

Trailer Data Points

Trailer MID address, total trailer distance, trailer ABS lamp, battery voltage, and wheel speeds (j1708 only).

 

Data Points for Bendix ADB Wear Sensing

When an ADB Wear Sensing component is selected, the reported pad wear life status is displayed.

When a Bendix Continuous Wear Sensing component is selected, the estimated brake wear life (pads plus rotor) remaining is displayed.

Data Points for Bendix TPMS

When a TPMS component is selected the tire temperature and tire pressure for detected sensors is displayed. Blue axle numbers indicate Spare Tire sensors.

 

Data Points for Agility Fuel System

When an Agility Fuel System component is selected the following key data items are displayed: fuel storage pressure,fuel economy, percent idle time, total idle fuel used, total distance driven, fuel used, and both fuel temperature sensor readings.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

19 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago