Here show you guide on how to use Launch EasyDiag 3.0 or Golo 3.0 to perform ECU long coding for Skoda Laura 2011.In this example,we need recover long code after replacement ECU.And for more about Launch X431 products test,please check it here:How to use Launch X431
Preparations:
Launch EasyDiag 3.0 or Launch Golo 3.0 (Launch on Amazon)
DIAGZONE PRO App
Procedures:
Connect EasyDiag 3.0 or Golo 3.0 to Skoda Laura obd port,then run DIAGZONE PRO on your mobile phone.
Select “Skoda”
It will build connection to Skoda Laura,just wait process..
Then select “System Selection”
Select “01 Engine Control Module”
Now here you are available to check the ECU information
The Long Coding:00000000000000000000
Press “OK” and select “Read DTCs” you will find there is a “P161200:Engine Control Module incorrect Coding” code.
Now you back to select “21 Long Code”
Now input the old 20 digits long coding,then press “OK”
And press “Save” to start long coding
Now you will find long coding finishing
And read DTC again,the P161200 disappeared.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…