How to Use MTX DTC Remover for Bosch EDC16U31

In this instruction,car-auto-repair.com will show the guide on how to use MTX DTC remover for Bosch EDC16U31.

 

Preparations:

MTX DTC Remover 1.8.5.0 Software Download

MTX DTC Remover 1.8.5.0 Installation & Activation Guide

 

MTX DTC Remover Test on Bosch EDC16U31:

Run MTX DTC Remover software,then select vehicle brand and ECU model “Bosch EDC16U1/U31/U34”

 

Now we upload our original file by clicking on the lens as below show:

 

Now decide where to save the file once processed (default DTC Remover saves it in the same folder of the file loaded by changing the extension to .dtcoff);

 

Now we can proceed in two ways: enter the OBD code or REF given to us by the diagnostic used or use the SCAN function in this example we will use the second

 

To use the SCAN function we click on the magnifying glass, after a few seconds the file will be analyzed and eventually you will see a table with the list of all OBD codes and REF detected (the REF codes are displayed as MAN in the list),hereinafter in sequence as below show

 

Now let’s choose what error going to try and insert it in the OBD (or if we also have the REF code can insert that too)

 

Added error code press the DTC button to process the file and after a while we will see in the infobar an expression show as below

 

If you click again on the SCAN button will see that the selected first error no longer has the flag displayed demonstrating that the error was disabled;

 

We have disabled our mistake and if we were to turn off other we just repeat steps 6 and 7 and when we’re done save it by pressing the SAVE button.

Done!