This article show a guide on how to use OPCOM to adjust clutch & gear adaptation Easytronic for Opel vehicles.For normal operation the Easytronic gearbox must periodically have maintenance work on adjusting the point of setting for the clutch and gear box adaptation.
Preparations:
Newest OPCOM VAUX-COM All Version Free Download
Procedures:
Diagnostics> Vehicle Type> Transmission> MTA Easytronic Next select Programming and the following menu will appear.
Adaptation point setting (Touch Point Adaptation)
1.Engine on and box in neutral position. Select Touch Point Adaptation
2.Follow the instructions that appear on the screen and observe the process of adaptation.
In the process of training the values are synchronously changed from larger to smaller and vice versa.
After the process has finished it will say settings stored, Programming done!
At the beginning of the process, you may receive the following Message: Conditions not correct!
You need to exit from the controller and from the program, Stop and restart the car, Re-enter the controller and repeat the process.
Learning Gearbox Parameters
1.For this procedure is you need to jack up the front wheels of the car so that they can rotate freely.
2.Turn the ignition but don’t start the engine until prompted. Select neutral with the handbrake on.
Confirm the choice by pressing OK.
The first phase will learn the gear positions 1st to 5th.
After the first part is complete, Push the brake pedal and start the engine, then click OK
Second phase will synchronize the gear positions.
Once the process has completed lower the vehicle to the ground and test drive.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…