Heavy Equipment Repair

How to use SerDia2010 to do Input Test A55 for Deutz Engine

This instruction show you guide on how to use SerDia2010 to perform input test A55 for Deutz engine.Especially for testing the control unit hardware part of this program was introduced. Despitevarious hardware fuses in the controller itself, it may happen that an output of the control unit through an improperly connected Component (e.g., a tank heater valve) destroys. With this test can be made an examination of the destroyed output “A55”. The test is not 100% reliable, you
should make another test to check the result.

After selecting and executing the Service Test Case Input A55 the following message appears on
the screen, which can be confirmed with the green arrow.

 

Related Contents:

2023 Deutz Serdia2010 v14.1.9.1 Diagnostic Software Free Download

Deutz Diagnostic Kit DECOM for Deutz Engine

 

 

Please follow these steps:

1 Assure that the new engine dataset is stored on the ECU

2 Assure that the main heater relais (K31) and tank heating valve (Y31) are electrically disconnected.

3 The next measurement will show the state of the ECU

If a test condition is not met, the process will be aborted with this message.

This service case can only be used with the BSW CV56B.The BSW CB56B is not installed on the ECU.The service case will be closed now. Deutz Communicator

This function is available at Competence Class Level 3.

auto

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

2 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

5 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

3 weeks ago