Categories: ECU Chip Tuning

How to Use VF2 Flasher to Read Data for Audi 6HP TCU

This instruction show you the procedure on how to use VF2 Flasher to read data for Audi 6HP TCU.More project of VF2,please check here:VF2 Flasher Feedback

 

Procedures:

Connect VF2 Flasher to Audi 6HP TCU and select “Bench”

Select “Vehicle Brand Model”

Select “CAR”–>”Audi”

Select”A6(4F2/4F5/4FH0C6)”–>”4.2L V8 FSI Quattro|Bosch 6HP19A”

Here you can press “Instruction” to check wire diagram,after then press “Select” to continue.

Click “IDENTIFY”

Success ID OK!

Then click “Read” button

Checksum in progress

 

Then wait progress,success read ok!

Now you can select to create new folder to save the file

 

 

auto

Recent Posts

Volvo and Mack EPA 10 Engine Hydrocarbon Dosing Control Valve Test by JPRO

This instruction show you guide on how to perform hydrocarbon dosing control valve test for…

2 days ago

Fendt Tractor SPN 100 FMI 31 Oil Pressure Sensor Defect Solution

This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…

4 days ago

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure   Related Contents: 2024.06 Detroit Diesel…

6 days ago

Perkins 800 Series Engine Water Temperature Regulator Housing Remove and Install

This instruction show you guide on how to remove and install water temperature regulator housing.…

1 week ago

Monza, Kadett and Ipanema Multec 700 GM ECU Components Pinout

Monza, Kadett and Ipanema Multec 700 GM ECU Components Pinout   Vehicles: Monza, Kadett and…

1 week ago

How to Remove Oil Pressure Regulation Valve for CLAAS AXION 950

This illustration show you guide on how to remove oil pressure regulation valve for CLAAS…

1 week ago