This instruction show you guide on how to use WinEEM4 service tool software to do DPF regeneration.
Preparations:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
Procedures:
WinEEM4 service tool DPF regeneration provides the means to activate the DPF regeneration functionality. The graph in the middle of the page plots the temperatures which are most relevant to DPF regeneration process. Several other relevant values are displayed in the right side of the page.
When test is activated by user, engine speed will be set automatically to ~1500 rpm. Engine Management System then starts controlled DPF regeneration process. The process takes about 30-50 minutes, time may vary due to environmental conditions and DPF soot load level. During DPF regeneration engine noise level may vary. Process progress will be shown to user. After DPF regeneration engine will return to low idle. Let engine cool down on low idle minimum of 2 minutes before shutdown.
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…
Here is the instruction show you guide on how to solve Caterpillar C9 fault code 64-2…
This instruction show you guide on how to bleed air from the fuel system for…
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…