Categories: Auto Key Program

How to Use Zed-Full Reset Subaru G Chip IMMO

This instruction show you guide on how to use Zed-FULL programmer to reset Subaru G chip IMMO system.And for more Subaru immobiliser,please check here:Subaru Key Programming

 

Procedures:

Connect Zed-Full to Subaru OBD port,then enter menu to select “OBD Application”

Select “Subaru”

Turn ignition Off/ON the press “Continue”

If all keys are lost,immobiliser must be reset in order to program a new key to the vehicle.

Select “IMMO RESET” the press “Continue” button

Turn ignition Off/ON the press “Continue”

Resetting immobiliser unit,this will take up to 16 minutes

Remove and insert the same key ensuring that the ignition is on.Wait for chimes to stop before continuing.

During immobiliser reset,immobiliser light will stay on and car won’t start.

Immobiliser resest is completed,immo light goes off and the key in the ignition is programmed to the vehicle.

 

Turn ignition off and on,then make sure the programmed key starts the vehicle

 

Done!

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

21 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago