Categories: Auto Coding

How To:BMW Mini R56 Coding Guide

This is a guide on how to coding for BMW Mini R56.Follow this instruction to get the many coding features for BMW Mini R56 options.

What You Need for Coding for BMW Mini R56 Coding?

BMW K+CAN Cable

BMW Expert Coding Software Download

BMW Coding/Flashing/Progrmming PDF+Video Guide

NCS Expert program and coding guide

 

BMW Mini R56 Coding Sheet

FunctionTitle Description Module Function value 2007 2008 2009 2010 2011 2012
Remote closing windows Comfort
close windows by holding the “lock” button on the key fob. Change
from nicht_aktiv to aktiv.
CAS KOMFORTSCHLIESSUNG_FB X X X X X X
Auto Door Unlock Unlocks
all doors when you remove key (regular) or when the engine shuts off (comfort
access).Auto-locking needs to be
enabled for this to work.
CAS ER_KEYOUT_AUTOVR X X X X X X
Selective Unlocking with Remote Unlocks
just the driver’s door (aktiv) or all doors (nicht_aktiv) when
unlocking. Set separately for
each remote (x = 1,2,3,4)
CAS SEL_ZV_SENDER_x X
Power Windows after Ignition Deactivation Enables
power windows for one minute after ignition is turned off
CAS FH_ABSCHALTKRITERIUM X X X
Efficient Dynamics shift indicator suggestions enable when
crusing
Just
change SCHALT_PKT_DAUERHAFT from nicht_activ to activ
KOMBI SCHALT_PKT_DAUERHAFT X
Always Show Digital Speed Will
make your speed always show like the 2011 Models. You can see your MPG and
speed at the same time! Or you can reverse it to have your 2011 act like the
older models.
KOMBI DIG_SPEED_PERMANENT X X X X X X
Disable speed overestimation Will
make the speed on the tach more correct instead of 2-7 MPH faster than actual
speed if set to nicht_activ.
KOMBI BC_DIGITAL_V_KORREKTUR X X X X X
Key Gong Reminder -door open Will
shut off the chime when the keyfob is in the slot and the door is opened.
Change to activ to enable.
KOMBI CC_ZUENDSCHLUESSEL X X X X X X
Road Freeze Temperature Warning Change
to nicht_aktiv to eliminate the Check Control message when the temp falls
past 37°F
KOMBI CC_TEMPERATURWARNUNG
Opening Doors Will Not Interrupt Window Roll Up Opening
doors will not interrupt window roll up operation. Normally, if you open a
door while the window is automatically rolling up, it will stop
the operation. This feature diables it. Change to nicht_activ.
FRM2 TUERAUF_STOP_MAUT X X X X X X
Double-Blink Hazard Lights Makes
the emergency lights blink twice.
FRM2 DOPPELBLINKIMPULS_WARNBLK X X X X X
Fogs and High Beams On Simultaneously Allows
fog lights to be on while high beams are also on. Needs to be changed to
nicht_activ.
FRM2 FL_UND_NSW_NICHT_GLEICHZ X X X X X X
Fogs and High Beam Flash On Simultaneously Allows
fog lights to be on while high beams are flashed. Needs to be changed to
nicht_activ.
FRM LH_UND_NSW_NICHT_GLEICHZ X X X X
DRL Change Mods Need
to change the value from drl_l to drl_tfl_off. Will let you have option of
turning headlights off and DRL. If lights are OFF, you wont have welcoming
lights when car is opened/closed.
FRM2 VERHALTEN_DRL_TFL X X X
Front City Light (fog light housing) ONLY as DRL Set 1 of 2 set
to drl_s
FRM2 VERHALTEN_DRL_TFL X
Front City Light (fog light housing) ONLY as DRL Set 2 of 2 set
to aktiv; you can still turn them
off and on via the BC menu. You
may also need to set the following to nicht_aktiv: DRL_TFL_BLK_V_GED,
DRL_TFL_KZL, DRL_TFL_RL_BL, DRL_TFL_RL_BL_1, DRL_TFL_RL_BL_2
FRM2 DRL_TFL_MIT_SML X
Disable A/C Engagement When Pressing the Auto Button When
you press the “Auto” button on the climate control, the A/C
(compressor) will not engage automatically unless it was previously engaged.
INHKA KLIMA_MIT_AUTO X X X X X
Disable NAV System Warning Disable
the navigation warning message on start-up.
CAPPL LEGAL_DISCL X X X
Sunroof Auto Open/Close Change
to aktiv – Opens from “tilt
open” to “full open”.
SHD SCHIEBEHEBEDACH_TIPP_AUF X X X X X X
You must change all four Change
to aktiv – Closes from “tilt open”.
SHD SCHIEBEHEBEDACH_TIPP_SENK X X X X X X
in order to enable two-touch Change
to aktiv – Closes from “full open” to
“tilt open”.
SHD SCHIEBEHEBEDACH_TIPP_ZU X X X X X X
sun roof opening/closing. Leave
as aktiv – Opens from “closed” to “tilt open”.
SHD SCHIEBEHEBEDACH_TIPP_HEB X X X X X X
Enable alarm system Will
enable the DWA heartbeat warning light on the tach (even if you don’t have
the alarm hardware installed). Change to aktiv to enable. (Alternative: add
$302 to the VO)
SPEG DWA_VERBAUT X X X
Disable Seat Belt Chime Change
to disable seat belt warning for PASSENGER.
ABG/MRS SBR_BEIFAHRER X X X X X X
Change
to disable seat belt warning for DRIVER.
ABG/MRS SBR_FAHRER X X X X X X
Disables
seat belt warning on startup
ABG/MRS CC_GURTWARNUNG X X
Disable
Driver Seatbelt Reminder; Add to Vehicle Order string (both FRM&CAS) and
default modules to make permanent.
VehicleOrder OI11 X
Disable
PASSENGER Seatbelt Reminder; Add to Vehicle Order string (both FRM&CAS)
and default modules to make permanent.
VehicleOrder OI12 X
Change Standard (Boost) Radio Filter Settings Disables
100 Hz Rear Cutoff (Caution! Over-driving your rear speakers may damageyour head unit!! Only use this if you have an aftermarket DSP!!)
Change “r56_stereo” to “56_hifi” to disable cutoff.
2RAD VEHICLE_FILTERS X X X
Enable memory function of MSA Start/Stop-Button MSA
Start/Stop-Button will keep the latest value (value off will also off at the
next engine start; change the option to aktiv)
SPEG MSA_TASTER_MEM_FUNKT X X X
Disable Bulb checks
(Cold Monitoring Checking) Disables
low beam cold monitoring bulb check. Set to nicht_aktiv.
FRM KALTUE_AL_M1_6_M2_38 X
Disables
high beam cold monitoring bulb check.
Set to nicht_aktiv.
FRM KALTUE_FL_M2_6_M1_04 X
Disables
license plate lights cold monitoring bulb check. Set to nicht_aktiv.
FRM KALTUE_KZL_M2_49 X
Disables
reverse light cold monitoring bulb check. Set to nicht_aktiv. (R = right, L =
left)
FRM KALTUE_RFS_R_M1_9
KALTUE_RFS_L_M1_9
X
Disables
rear fog light cold monitoring bulb check. Set to nicht_aktiv. (R = right, L =
left)
FRM KALTUE_NSL_R_M2_51
KALTUE_NSL_L_M2_51
X
(Warm Monitor Checking) Disables
low beam warm monitoring bulb check.
Set to nicht_aktiv.
FRM WARMUE_AL_M1_6_M2_38 X
Disables
high beam warm monitoring bulb check.
Set to nicht_aktiv.
FRM WARMUE_FL_M2_6_M1_4 X
Disables
license plate lights warm monitoring bulb check. Set to nicht_aktiv.
FRM WARMUE_KZL_M2_49 X
Disables
reverse light warm monitoring bulb check. Set to nicht_aktiv. (R = right, L =
left)
FRM WARMUE_RFS_R_M1_9
WARMUE_RFS_L_M1_9
Disables
rear fog light warm monitoring bulb check. Set to nicht_aktiv. (R = right, L =
left)
FRM WARMUE_NSL_R_M2_51
WARMUE_NSL_L_M2_51
Enable one-touch windows on R56 models (driver) Enables
one touch up and down of windows instead of holding to open or close on 2007+
models. Change from nicht_aktiv
to aktiv. (alexs3d2)
FRM FH_MAUT_ZU_ACTIV_FAT X
Enable one-touch windows on R56 modes (Co-driver) Same
as above, but for co-driver’s window. (nicht_aktiv to aktiv). (alexs3d2)
FRM FH_MAUT_ZU_ACTIV_BFT X
Enable one-touch windows on R56 models (driver) Enables
one touch up and down of windows instead of holding to open or close. Change
from nicht_aktiv to aktiv.
FRM3 FH_MAUT_ZU_FAT_ENABLE X
Enable one-touch windows on R56 modes (Co-driver) Same
as above, but for co-driver’s window. (nicht_aktiv to aktiv).
FRM3 FH_MAUT_ZU_BFT_ENABLE X
Weather Band Radio Enables
weatherband on radio menu,change from nicht_aktiv to aktiv.
CHAMP RADIO_WEATHERBAND X X
Remove Legal disclaimer from Connected or Nav Takes
away the legal disclaimer you have to look at every time you start the
car. Change to kein_ld. Factory setting is ld_mit_timeout
CHAMP LEGAL_DISCLAIMER X X
Remove Region specific restrictions For
example, to get a Canada car to allow you to enable or disable your DRL from
the BC, remove $838 from the VO (both CAS & FRM) and default the vehicle
(or at least KOMBI module)
VehicleOrder $8AA
China, $8LA India, $8LF Deutschland, $8LH Hong Kong, $8LR Russia, $8LS
Singapore, $8LT Taiwan, $801 Germany, $802 Korea, $807 Japan, $810 Australia,
$812 England, $822 Kuwait/Abu Dhabi/Bahrain/Kata/Oman/Saudi Arabia, $838
Canada
Remove US Tire Pressure Monitoring Remove
$2VB from VO (both CAS & FRM) and “default” vehicle. May also need to pull the fuse for the
TPMS system as well.
VehicleOrder $2VB X
Deactivate Engine Start/Stop (MSA) Add
OMSA to the VO and default vehicle
VehicleOrder OMSA
Retrofit IBOC (HD Radio) Add
$653 to the VO (both CAS & FRM) and default vehicle (or at least the RAD2
or media system).
VehicleOrder 653 X
Retrofit Bluetooth & USB ULF Add
$6ND to the VO (both CAS & FRM) and default vehicle (or at least the RAD2
or media system).
VehicleOrder $6ND X
Retrofit SDARS (US Sat Radio) Add
$655 to the VO (both CAS & FRM) and default vehicle (or at least the RAD2
or media system).
VehicleOrder 655
Retrofit Sport Button Add
$4UF to the VO (both CAS & FRM) and default vehicle (or at least the RAD2
or media system).
VehicleOrder $4UF X X
Retrofit Front Fog Lights Add
$520 to the VO (both CAS & FRM) and default vehicle (or at least the FRM
& IHK).
VehicleOrder 520
Retrofit Rear Fog Lights Add
$588 to the VO (both CAS & FRM) and default vehicle (or at least the FRM
& IHK).
VehicleOrder 588
Retrofit Rear Fog Lights Add
$5AA to the VO (both CAS & FRM) and default vehicle
VehicleOrder $5AA X
Retrofit Alarm System (or just the blinking tach light) Add
$302 to the VO (both CAS & FRM) and default vehicle (or at least KOMBI
& SPEG), you can use this to enable the heartbeat if you don’t install
the siren & ultrasonic interior sensor
VehicleOrder 302 X
Retrofit Rear Fog Light Change
to aktiv – Activates rear fog
light. Performed on 2009 R56
standard model (not the Sport)
IHKS NEBEL_SCHLUSSLEUCHTE X
Retrofit OnBoardComputer Add
$550 to the VO (both CAS & FRM) and default vehicle (gives full OBC for
vehicles with limited OBC-functions)
VehicleOrder 550 X X X X X X
Retrofit Heated Seats Add
all the hardware, then afterwards add $494 to the VO (CAS and FRM), and then
default FRM, CAS, SPEG and IHKA
VehicleOrder 494 X
auto

Recent Posts

Fendt MT800E Tractor DEF Tank Temperature Does Not Change Solution

Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…

9 hours ago

HITACHI Construction 4JJ1 P0092 Fuel Pressure Regulator Control Circuit High

Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…

2 days ago

How to Solve Perkins 1106D EPG Engine E398 Low Fuel Rail Pressure Error

Here is the illustration show you guide on how to solve Perkins 1106D electric power…

2 days ago

Deutz EMR3 Aassembly Inspection and Initialisation Test Guide

Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…

4 days ago

HITACHI ZX-5 Excavator No Load Max Differential Pressure Measurement Guide

This instruction show you guide on how to perform No load max differential pressure measurement…

4 days ago

How to Solve Doosan Machine P02EB Over Temperature Error

Here is the instruction show you guide on how to solve Doosan machine P02EB over…

5 days ago