Here is an illustration show you steps on how to remove and install fule filter for ISUZU 4LE2 Tier-4 engine.
Related Contents:
ISUZU E-IDSS 2024 2019 Engine Diagnostic Service System Free Download
ISUZU IDSS MX2-T Diagnostic Tool
Procedures:
Fuel Filter Removal
1 Disconnect the harness connector from the fuel sedimenter switch.
2 Remove the fuel feed hose from the fuel filter.
Caution: To prevent fuel outflow, be sure to plug the disconnected hose.
3 Remove the fuel return hose from the fuel filter.
Caution:To prevent fuel outflow, be sure to plug the disconnected hose.
4 Remove the fuel filter from the engine.
Fuel Filter Installation
1 Install the fuel filter to the engine.
2 Install the fuel return hose to the fuel filter.
3 Install the fuel feed hose to the fuel filter.
4 Connect the harness connector to the fuel sedimenter switch.
2 Fuel Filter Air Bleed
1 Loosen the plug using a wrench.
2 Operate the priming pump.
Note: Press the priming pump until it becomes hard.
3 Tighten the plug using a wrench.
tightening torque: 10 N・m { 1.0 kgf・m / 89 lb・in }
4 Operate the priming pump.
Note:Operate until the opening sound of the overflow valve is heard.
More repair cases for ISUZU engine,please refer to:ISUZU Engine Trouble Repair
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…
This instruction show you guide on how to use AGCO EDT diagnostic software to perform…