Categories: Truck Repair

ISUZU N-Series Fuel Injector Flow Rate Programming by IDSS

When replacing the injector,it is necessary to register the ID code printed on the upper part of the injector with handheld tester in the engine ECU.So here i will show you guide on how to use IDSS software to do fuel injector flow rate programming after replacement.

 

Note:If the ID code of the newly installed injector is not properly registered,rough idling,abnormal noise,or other symptoms may occur.

 

Preparations:

2023 2019 Isuzu G-IDSS Export Diagnostic Software Free Download

 

Procedures:

Connect Nexiq interface to ISUZU diagnostic port,then run IDSS software.

After vehicle identification,select “Control Programming”–>”Engine Control Module Programming”–>”Inject Flow Rates”

Select which injectors you have replaced,then click “Next”

Click each of the tabs below and enter injector Flow values.You must enter injector flow values for all injectors before pressing “Reprogram Injector Flow Rates”,or press Back to cancel

Click on a cell in the grid to the left to edit.

Characters can only be 0-9 and A-F.

When finish injector 1-injector 4,click “Reprogram injector Flow Rates”

Turn off the ignition and press “Next” to complete the programming process.

Turn ON the ignition and press “Next” to complete the programming process.

Programming Complete!

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

2 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

2 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

3 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago