This instruction show you guide on how to solve JCB JS140/205/215 excavator C1022-13 trouble code coolant temperature sensor open circuit error.
Possible Cause:
1 Coolant temperature sensor wire harness not connected to Coolant temperature sensor.
2 Faulty coolant temperature sensor.
3 Poor wire harness connection at MECU.
Related Contents:
2025 JCB ServiceMaster 4 v25.1.0 Free Download for Win 10 Win11
2017 JCB Parts Plus+ and Repair Service Manual Free Download
Diagnosis:
1 Check the coolant temperature wire harness connector connected to coolant temperature sensor on engine or not. Refer below photograph.
2 Check the coolant temperature sensor resistance by help of multimeter.At 80°C the approximate resistance of sensor shall be 323Ω.
3 Check the circuit 4069 in cavity 17 & circuit 4303D in cavity 3 of MECU connector are connected properly or
not. In cavity 17 & Cavity 3 terminal back out should not there.
Corrective Action:
1 Connect the wire harness with the Coolant temperature sensor.
2 Replace the faulty sensor.
3 Connect MECU with machine wire harness properly.
More topics for JCB machine,please refer to:JCB Machine Trouble Repair.
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…
This instruction show you guide on how to use AGCO EDT diagnostic software to perform…
This instruction show you guide on how to remove folding stairway and surrounding part for…