Here is the instruction show you guide on how to use Launch X431 PAD5 Link HD to do PWM signal to altemator for Scania G410 truck.
Related Contents:
Procedures:
Connect SmartLink C V2.0 adapter to Scania truck OBD port
Then select “Local Diagnostic” and select “Scania”
Select “CAN Automatic Identification”
Click on “System Scan” for a full vehicle checkup
Wait all system scan process finish,then select “EMS (Engine Management System)” to enter
Truck identification information
Select “Actuation Test”
Select “PWM Signal To Alternator”
Test Conditions:
During Actuation,the engine RPM and vehicle speed must be 0.If the engine RPM and vehicle speed are recorded or signal is lost,actuation is impossible.
Now here you are able to input new value to test.
11
Enjoy!
This is an illustration on how to solve Massey Ferguson 6700 tractor SPN 29, FMI…
Here is the troubleshooting guide on how to solve HINO J05E engine 2018 P0045 DC…
Here is a solution for Allison 3000 & 4000 Gen 5 P0614 torque control mismatch…
Here is the instruction show you guide on how to solve JCB Tier 4 engine…
This instruction show you guide on how to use AGCO EDT diagnostic software to do…
This illustration show you guide on how to solve PCC1302 PowerCommand trouble code 1847 engine…