Heavy Equipment Repair

Massey Ferguson Tractor 6700 SPN 84, FMI 3 Vechicle Speed Sensor Short to High

Here is the instruction show you guide on how to solve Massey Ferguson Tractor 6700 trouble code SPN 84, FMI 3, Vechicle speed sensor short to high SOURCE.

Preparations:

AGCO EDT 2024

AGCO 2×4 CANUSB

 

Description

The EEM4 monitoring system has detected a short circuit on the vehicle speed sensor.

 

Possible causes are:

The speed sensor wiring is defective (Shorted to high source.)

The speed sensor is defective

 

Reaction in EEM

The FC is stored and the warning lamp is activated. The CAN message indicates active fault.

 

Solution

First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:

 

Check the vehicle speed sensor connection to the EEM4, the connectors and the contact surfaces of the connector pins (possible oxidation).

Check the operation with another speed sensor to see if the speed sensor is defective.

auto

Recent Posts

QSK60 CM2358 Engine Camshaft Speed/Position Sensor Data Erratic Incorrect

This illustration show you guide on how to repair Cummings QSK60 CM2358 engine camshaft speed/position…

4 days ago

Fendt MT800E Tractor DEF Tank Temperature Does Not Change Solution

Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…

6 days ago

HITACHI Construction 4JJ1 P0092 Fuel Pressure Regulator Control Circuit High

Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…

1 week ago

How to Solve Perkins 1106D EPG Engine E398 Low Fuel Rail Pressure Error

Here is the illustration show you guide on how to solve Perkins 1106D electric power…

1 week ago

Deutz EMR3 Aassembly Inspection and Initialisation Test Guide

Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…

1 week ago

HITACHI ZX-5 Excavator No Load Max Differential Pressure Measurement Guide

This instruction show you guide on how to perform No load max differential pressure measurement…

1 week ago