Heavy Equipment Repair

Massey Ferguson Tractor 6700 SPN 94, FMI 3 Fuel Pressure Sensor Voltage Above Normal

How to solve Massey Ferguson Tractor 6700 trouble codes SPN 94, FMI 3, Fuel main filter inlet pressure sensor voltage above normal or open circuit

Preparations:

AGCO EDT 2024

AGCO 2×4 CANUSB

 

 

Description

The measured fuel filter pressure signal is above the normal operating range (> 4,6 V).

 

Possible causes are:

The fuel filter pressure sensor wiring is defective.

The fuel filter pressure sensor power supply is not correct.

The fuel filter pressure sensor is defective.

 

Reaction in EEM

The FC is stored and the warning lamp is activated. Engine power will be reduced (Degradation Level 1). The CAN message indicates active fault. Engine functions that depend on the fuel filter pressure are not active.

 

Solution

First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:

Check the fuel filter pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).

Check the 5 V power supply to the sensor.

Check the operation with another fuel filter pressure sensor to see if the fuel filter pressure sensor is defective.

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

6 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago