Here is the instruction show you guide on how to solve Massey Ferguson tractor 6700 trouble code SPN 97,FMI 31 water in fuel problem.
Preparations:
Description
The water level in the water separator has risen to the warning level. Example: condensation water.
Reaction in EEM
The FC is stored and the warning lamp is activated. Engine power will be reduced (Degradation Level 2).The CAN message indicates active fault.
Solution
Check the water separator at the bottom of the pre-filter. Drain the water from the fueling system.
If there is no water in the fueling system:
Remove the sensor from the fuel filter and clean the sensor element
Check the sensor operation with water cup by sinking the sensor element to the water for 1 minute. If fault code appears sensor is functional.
Check the wiring from the ECU to the sensor connector.
Check the supply voltage at the water detector sensor connector pins A (+12V) to pin C (GND).
If the power supply to the sensor is correct, and there are no breaks or short circuits in the wirings -> replace the sensor.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…