Categories: Auto Repair

Mercedes Benz ELV Repair by CGDI MB (OBD Method)

I wrote a article on Benz ELV repair guide before: 2 Ways To Repair Benz ELV/ESL Steer Lock Problem.You need to remove the NEC chip then use VVDI MB Tool to restore the damaged data.Now here I introduce another device (CGDI MB Prog) to repair Benz ELV trouble by OBD port.

 

Vehicle Models Apply:

Benz W204,W207,W212

 

Step 1:Determine if the ELV motor work correctly.

Remove the ELV control module from vehicle with wire connector connecting.And connect the clip on the yellow line of the OBD line to the K-line (K-line is the thinnest) of ELV

Connect CGDI MB to vehicle via OBD port,then run the software and click”Read ELV Data”

The software will show the ELV information after data reading successfully.

Then click “Check ELV”,if the ELV is work,it will prompt “ELV is OK!”.If the ELV is damaged (motor trouble),you need to replace a ELV motor or replace it by ELV emulator.

 

Step 2:Erase ELV

Click “Get” to calculate the “Erase password”,then it will show “Erase password calculated successfully”

Click “Erase ELV”,software will prompt you “Erase the ELV success”

Then click “Read ELV Data” again,it show the ELV information as below

 

Step 3:Calculate IMMO Password

Click “Read EIS Data”

Select “Compute Password”àCheck “Copy key with key”(If all keys lost,choose copy key without key)

Default “other key s “, click OK

Then according to the software to operate,you will get the IMMO password.

Click “Copy”,then select “EIS” menu to paste the password

Then click “Save EIS Data” (Please use default file name)

Insert the simulation key into the EIS about 30 seconds

Then click “Wipe the EIS”

Erase the EIS success!

Read the EIS data again,

Then click “Load EIS Data” to load the EIS data you save before.

Click “Write EIS Data”

Follow the software to insert the simulation key into the EIS about 30 seconds.

Write EIS data successfully.

Read EIS Data again to check information

Click “Sync W204 ELV”,it will prompt “Sycn W204 ELV success,please insert key into EIS for activation”

 

After activation successfully,the ELV will work correctly.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

7 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago