Categories: Auto Repair

Mini R56 Misfire Abnormal Vibration Diagnosis & Repair by G-scan2

This article show a guide on how to use G-scan2 to diagnose and repair BMW Mini R56 engine misfire problem.

 

Trouble Description:

Engine misfire and abnormal vibration form then engine &unstable/rough idle speed.

 

Trouble Diagnose:

Connect G-scan2 to vehicle and select “DIAGNOSIS”

Select correct model:Mini Hatch 2013

Select Drive,DME (Digital Motor Electronics) in order to diagnose engine.

Select “Read fault memory” to check if there is any present DTCs.

This Mini has a ignition coil problem in Cylinder #2.

Select “Diagnosis scan” and “Misfire Detection”,then tap “OK” to continue

As soon as the engine is started,G-scan2 detects the misfire rate in cylinder #2.

Select all item,and tap “Graph”

Now we get the cylinder 1-4 data graph as below

And we can suspect the Coil on cylinder #2 is bad

Now we need to replace the coil for cylinder #2.

After completing cylinder #2 coil replacement,check if we fixed the proble.

Connect G-scan2 again and select correct model& system

 

Erase the DTCs and see if it comes back again

And back to menu to “Diagnosis scan” to check the cylinder 1-4 data graph

You can see the misfire is gone and the idle is more smoother than before.

Done!

auto

Recent Posts

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

3 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

5 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago

How to do Perform Cylinder Cut-off Test for Massey Ferguson Tractor

This instruction show you guide on how to use AGCO EDT diagnostic software to perform…

3 weeks ago