This article show a guide on how to use Nissan Consult 3 Plus to active engine power balance test.Hope it helps,and if you want to know more about Nissan Consult 3 Plus,check:Nissan Consult 3 Plus Projects.
Related Contents:
Nissan Consult 3 Plus Software Download
How to Install Nissan Consult 3 III Plus Diagnostic Software
Nissan Consult 3 Plus Clone Interface
Procedures:
Connect Nissan Consult 3 Plus to vehicle,then run software.
1.Conducting Active Test:From the “All DTC” screen, select the system you need to test.-In this example we will be looking at the Engine ECU.
2.From the “Self Diagnosis Results” screen, select the “Active Test”tab.
3.Select the item that requires the test.In this scenario, a “POWER BALANCE” test is being performed to determine which cylinder on the engine is not firing or which cylinder has the weakest performance.
4.Numerous inputs can be checked whilst the test is being carried out.
In the case of performing a cylinder Balance test, the technician will need to monitor air flow quantity & engine RPM.
Select the desired items & then click “Start”.
5.Select “Monitor Start”and current engine operating values will be displayed.
6.Select the cylinder to test (arrowed) and then click on “Test Start”.
Current engine operating values are now displayed (circled). Record this data and then click on “Reset” to select another cylinder.
Repeat for all cylinders.
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…