Categories: Auto Repair

Nissan Maxima 2017 Idle Air Volume Learning by Launch X431 Throttle

In this post we are going to tech you how to use Launch X431 to perform air volume leaning for Nissan Maxima 2017.And for more Nissan repair,please check:Nissan Trouble Repair.

 

Procedures:

After you build connection between Nissan and Launch X431 Throttle,enter vehicle menu to select “Nissan”–>”The Vehicle With 16PIN”

After confirm vehicle information,select “Automatic Selection(VIN)”

Confirm your vehicle VIN,model and year,select “OK”

Select “ECM(Engine Control Module)”

Select “Special Function”–>”Idle Air Vol Learn”

This function allows the ecm to learn the position of the IACV-AAC which maintains proper engine speed at idle! Always perform this mode after replacement of IACV-AAC valve,throttle body,ECM or when idle speed or ignition timing is out of specification.To confirm the vehicle condition such as coolant temperature to perform this operation,service manual must be checked for the detail.

Click “OK” to continue

After then,for self learn,select “Automatic Matching”

And then click “Start”,it will begin idle air vol learn,and then just wait for process finish.

 

And for Manual Matching,please follow below steps:

Then follow instruction to select “OK”

Done!

More Launch X431 Training article,please check here:Launch X431 use guide

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

7 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago