In this instruction,car-auto-repair.com will show you guide on how to perform Nissan Maxima 2017 target ignition timing adjustment by Launch X431.For more Nissan projects,please follow this tag:Nissan Repair Cases.
Procedures:
Connect LAUNCH X431 Throttle to Nissan OBD port,then enter menu to select “Nissan”
Select “The vehicle with 16 pin”
Confirm VIN,select “OK”
Select “Automatic Selection”
Confirm your car VIN,year and model,select “OK”
Select “System Selection”
It will show you with the system information,just select “OK” to continue
Select “Special Function”
Select “Target Ign Tim Adj”
A system information screen will give you instruction:
Touch “Start” and adjust idle ignition timing under the following conditions:
Engine is warmed up
Loads(Air conditioner,Lights,ETC.) are off
Function is not normally required during the usual service procedure
Click “OK” to continue
Now you can select “Up” or “Down” to adjust the ignition time,and the select “Update” after an adjustment is made
Done!
More Launch X431 Training article,please check here:Launch X431 use guide
This instruction show you guide on how to perform hydrocarbon dosing control valve test for…
This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…
Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure Related Contents: 2024.06 Detroit Diesel…
This instruction show you guide on how to remove and install water temperature regulator housing.…
Monza, Kadett and Ipanema Multec 700 GM ECU Components Pinout Vehicles: Monza, Kadett and…
This illustration show you guide on how to remove oil pressure regulation valve for CLAAS…